#DD WRT V24 SP2 WIRELESS BRIDGE SETUP DOWNLOAD#
#DD WRT V24 SP2 WIRELESS BRIDGE SETUP WINDOWS 7#
On Windows 7 Network Map, PCs from Router 2 network appear connected through a Bridge, as opposed to Switch for devices on Router 1 network.Ī quick tip for those new to Linux and struggling to access their DD-WRT router over Telnet. Does not ask for a password, will use the configuration on Wireless pages.
Status -> Wireless -> Site survey to Join a network. I am only using 1 physical wireless interface on both routers for this setup, no virtual ones. Preamble = Short (read in some article on the net, not sure if it’s needed or not). Router (Router 2), LAN & WAN (LAN would probably work too, since WAN is disabled).Īdvanced Wireless Settings. Setup - Advanced Routing, operating mode: WAN Connection Type = Automatic configuration - DHCP. Both internet and local network are now working. TP-Link TL-WR1043ND, same version, regular firwmare (8MB), later Router 2.ĭespite routers run on Broadcom and Atheros chips, it was possible to configure them to cooperate. Asus RT-N12, DD-WRT v24-sp2 build 14896 (08/07/10), mini image (4MB firmware size), connected to the internet, later being referred to as Router 1.